Shitposting without technically shitposting. Well done!
Don’t you just hate being out and about, need a toilet, and there’s a DRM lock? Why I only support open source Klipper now.
This made my day.
You know mine became a spray paint can after eating a salad last month.
I’d say more extruders but I’ll give it to you.
By that definition all printers are also 3D printers.
I don’t know about you but I’m not creating a 2 image with my turds.
writing your name in the snow is more fun in brown ink
my ui doesn’t render that (it’s the web UI)
While you’re in the shower don’t forget to clean your printer.
And like real 3D printers, some “extruders” are really hot.
Instructions unclear. How to remove PLA from urethra?
PSA, don’t home-make catethers.
You weren’t supposed to do a cold pull.
I refer to my wife as a 3D printer. After all, she is the mother to my children.
I’ve never been able to get mine to work over wifi.
What a day to know how to read.
Organic 3D printers.
Mine seems to run a little cold, get a lot of layer separation.
How many layers can you even coil?
Your question requires testing. I’ll get back to you with my fiber and hydration settings
You are printing from too far away.
I’ll never think of the word extruder the same again
They’re just the nozzle, right? I’d say the body attached to it is the printer, and a good fiber diet is the filament
Tried installing a 0.4mm nozzle, now I have a hernia from pushing
Were you able to achieve a satisfactory resolution?
Yeah, but my setup wobbles too much so the VFAs were terrible. Pressure advance wasn’t well tuned either.
